OpenArt Logo
Sign in
Payman joudizadeh

Payman joudizadeh

Width: 1432
Height: 1432

Create your first image using OpenArt.

With over 100+ models and styles to choose from, you can create stunning images.

More images like this
Prompt:
Prompt:
Prompt: circuit diagram of Raspberry weather station for wiring connections between weather sensors, jumper wires, resistors and power supply etc.
Prompt: A detailed CAD drawing for EVE LF100 16S 48V configuration
Prompt: A combined photo of the repair of the inverter refrigerator and air conditioner motherboard with an explanation of the repair text
Prompt: germanium
Prompt: The IR emitter LED continuously emits infrared. When any object comes within the range, some amount of infrared reflects from the object’s surface and that reflected infrared can be detected by the IR receiver LED. The LM358 compares the voltage across the IR receiver LED with the predefined value. When any motion is detected the voltage across the IR receiver crosses the predefined value, so the output pin (pin 1) of LM358 becomes high. The clock pin (Pin-14) of CD4017 IC is connected to the output pin of LM358. So when any motion is detected, the 4017 IC receives a clock pulse and changes the current state of Pin-2. The Pin-2 of CD4017 is connected with the base of the BC547 NPN transistor, So when the Pin-2 becomes high the transistor turns on. When the transistor turns on, the current can flow through the relay coil. So the load connected with the relay also turns on. When the IR LEDs detect any motion the second time, it sends the next clock pulse to CD4017 IC. Then the Pin-2 becomes low. If the Pin-2 becomes low, the transistor turns off, and accordingly the load connected with the relay also turns off.
Prompt: germanium
Prompt: Generative pre-trained transformer
Prompt: automata printed circuit board by AI