OpenArt Logo
Sign in

Ajitpal Singh

Ajitpal Singh

Model: OpenArt SDXL

Prompt:

circuit diagram of Raspberry weather station for wiring connections between weather sensors, jumper wires, resistors and power supply etc.
Width: 1024
Height: 1024
Scale: 7
Steps: 25
Seed: 1103378845
Sampler: DPM++ 2M SDE Karras

Create your first image using OpenArt.

With over 100+ models and styles to choose from, you can create stunning images.

More images like this
Prompt: The IR emitter LED continuously emits infrared. When any object comes within the range, some amount of infrared reflects from the object’s surface and that reflected infrared can be detected by the IR receiver LED.
The LM358 compares the voltage across the IR receiver LED with the predefined value. When any motion is detected the voltage across the IR receiver crosses the predefined value, so the output pin (pin 1) of LM358 becomes high.
The clock pin (Pin-14) of CD4017 IC is connected to the output pin of LM358. So when any motion is detected, the 4017 IC receives a clock pulse and changes the current state of Pin-2.
The Pin-2 of CD4017 is connected with the base of the BC547 NPN transistor, So when the Pin-2 becomes high the transistor turns on.
When the transistor turns on, the current can flow through the relay coil. So the load connected with the relay also turns on.
When the IR LEDs detect any motion the second time, it sends the next clock pulse to CD4017 IC. Then the Pin-2 becomes low.
If the Pin-2 becomes low, the transistor turns off, and accordingly the load connected with the relay also turns off.
Prompt: automata printed circuit board  by AI
Prompt: Create an image of a detailed Gerber file for a drone control module PCB. The board should include several key components: a microcontroller unit (MCU), an inertial measurement unit (IMU), motor driver circuits, power management components, and various connectors for sensors and actuators. The PCB layout should show traces, vias, pads, and silkscreen labels. The overall design should reflect professional PCB design practices, with clear differentiation between top and bottom layers, ground planes, and signal routing. The image should be highly detailed, capturing the complexity and precision of the PCB design
Prompt: Nano hardware
Prompt: a computer board with a fan and wires attached to it and a mouse on top of it with a red and black fan, Dahlov Ipcar, purism, frostbite 3 engine, a computer rendering
Prompt: Create an image of a detailed Gerber file for a drone control module PCB. The board should include several key components: a microcontroller unit (MCU), an inertial measurement unit (IMU), motor driver circuits, power management components, and various connectors for sensors and actuators. The PCB layout should show traces, vias, pads, and silkscreen labels. The overall design should reflect professional PCB design practices, with clear differentiation between top and bottom layers, ground planes, and signal routing. The image should be highly detailed, capturing the complexity and precision of the PCB design
Prompt: germanium